V1.2.0 RELEASE NOTES
(Continued)
Global Parameters
Group 1
Group Select
Key
Parameter
Select Key
Sync Enable
Button Blinks
1.5 MIDI Clock Input
C#2
A#0
1 x / 5 x
The Matriarch Sequencer and Arpeggiator can be set to follow MIDI Clock, and can respond to Start and Stop commands received
via MIDI. Depending on your setup, you may wish for Matriarch to ignore some of these commands. Use the first three white keys
to select FOLLOW MIDI CLOCK + MIDI START/STOP COMMANDS (
C0
), FOLLOW MIDI CLOCK ONLY (Ignore MIDI Start/Stop
commands) (
D0
), or IGNORE ALL MIDI CLOCK + MIDI START/STOP COMMANDS (
E0
). The Default is FOLLOW MIDI CLOCK + MIDI
START/STOP COMMANDS.
1.6 MIDI Clock Output
C#2
C#1
1 x / 6 x
The Matriarch Sequencer and Arpeggiator can be set to output MIDI Clock, as well as MIDI Start and Stop commands.
Depending on your setup, you may wish for Matriarch to not send some of these commands. Use the first three white keys
to select SEND MIDI CLOCK + MIDI START/STOP COMMANDS (
C0
), SEND MIDI CLOCK ONLY (Do not send MIDI Start/Stop
commands) (
D0
), or DO NOT SEND MIDI CLOCK + MIDI START/STOP COMMANDS (
E0
). The Default is SEND MIDI CLOCK +
MIDI START/STOP COMMANDS.
1.7 Local Control (Keyboard)
C#2
D#1
1 x / 7 x
The Matriarch Keyboard, Pitch, and Modulation wheels can be disconnected from the internal synth engine, while still outputting
MIDI and CV/Gate data. Use the lowest two white keys to select Local Control (Keyboard) OFF (
C0
), or ON (
D0
). The Default is
ON.
1.8 Local Control (Arp / Seq)
C#2
F#1
1 x / 8 x
The Matriarch Arp / Sequencer module can be disconnected from the internal synth engine while still outputting MIDI and CV/
Gate data. Use the lowest two white keys to select Local Control (Arp / Seq) OFF (
C0
), or ON (
D0
). The Default is ON.
1.9 Receive Program Change
C#2
G#1
1 x / 9 x
MIDI Program Change commands (Program Numbers 1 through 12) can be used to load a previously saved Matriarch sequence,
and make it the active sequence. Turning this Global Setting OFF will prevent errant Program Change commands from
inadvertently activating a saved sequence. Use the lowest two white keys
to select OFF (
C0
), or ON (
D0
). The Default is ON.
1.10 Send Program Change
C#2
A#1
1 x / 10 x
Matriarch can be set to send a MIDI Program Change command (Program Numbers 1 through 12) when the
OCT / BANK
switch and
SEQUENCE
knob on the front panel are used to select and load a previously saved sequence from memory.
Turning this Global Setting OFF will prevent Program Change commands from being sent when a sequence is selected. Use the
lowest two white keys to select OFF (
C0
), or ON (
D0
). The Default is OFF.
