4
5
www.Deuba24online.de
www.Deuba24online.de
• Überprüfen Sie, ob die Glühlampe beschädigt
ist.
• Bewölktes Wetter kann die Aufladezeit der
Batterie vermindern. Überprüfen Sie die
Funktionsfähigkeit wieder nach einem sonnigen
Tag.
7. Batteriewechsel
Schrauben Sie die hinten angebrachte Abdeckung
der Leuchte ab.
Entfernen Sie die beiden Klammern und
entnehmen Sie die alte Batterie.
Setzen Sie die entsprechende wiederaufladbare
NI-MH Batterie ein.
Bringen Sie die Abdeckung wieder an.
Bitte recyceln Sie die Batterie
HINWEIS: Die Lichter werden mit LED (Licht
imitierende Diode) Technologie betrieben.
Wechseln Sie diese nicht selbst.
Only for domestic use and not for commercial
use!
Important
: Keep these Instructions for future
reference.
Unpack all the parts and elements of the set and
place the components on the top of the carton
or other clean surface. This protects your new
product. Please also pay attention not to scratch
the floor while working- with tools.
Keep small parts out of the reach of children.
Check the delivery for completeness. Later
complaints cannot be accepted.
Make sure that this product is fully assembled
before use .
Check all elements and parts for damages. Despite
careful checks since t may happen that even the
best product takes damage during the transport.
In this case, do not build up of your product.
Defective parts can endanger your health.
For cleaning use a sponge and warm soapy water.
Do not use solvent based-cleaners or detergents
for example Bleach those can damage the
product.
Please read and follow all instruction before
operating your solar light.
1. Part Contained
1.
The following part are included.
2.
Light head fixture 1pc
3.
Solar panel unit(with 5m double-cord electric
wire) 1pc
4.
Fix shelf 1pc
5. Flat head screw 5pcs
6.
Wall plugs 5pcs
2.Main Technical Specifications
1.
Solar board : 6V/40MA amorphous solar board
2.
Battery : 3.7v/500MAH Li re-chargeable battery
3.
Lamp : LED 15pcs
4.
Sensitivity : 2-6.5m
5. Delay time : 25sec
6.
Working ambient illuminance : <10Lux
3.Main Characteristics
In the daytime the panel absorbs sunlight which
charges the battery.
At night the light turns on when the movement
sensor is triggered, and the battery powers the
light.
4.Installation
a) Install solar panel
• Select location solar panel. A sunny location is
best. The brighter the light falling on the face of
the panel and the longer it is exposed to light
on the greater the charge your batteries will
receive. We advise putting it on a wall or roof.
• The electric wire is about 5m long so bare this
in mind when locating the solar panel and light.
• Attach solar panel using the flat screws and
nylon tube.
• Adjust angle of solar panel to make sure it can
collect as much sunlight as possible.
INSTRUCTIONS