14
15
Connector
Stop the backflow end of the pool with plug
Close the valve of the filtration system
3
、
Assembly and Operation Instruction
1. Remove the solar heating panel and its accessories from the box.
2. Wrap the joint with the teflon tape and screw it into the water inlet and outlet.
3. Install aluminum feet. Install the aluminum legs in the card slot on the main body
(see the figure below), push it to the end by hand, and hear the !click" sound to
indicate that it is installed in place.
4. Place the solar heating plate in the proper position and adjust the length of the
aluminum leg.
Note: Hold the end of the small aluminum tube with your hand, turn it
counterclockwise, then pull the aluminum tube out to the appropriate length, turn
clockwise, and lock the aluminum tube.
5. Turn off the power to the swimming pool filtration system, plug the back end of
the pool with a screw plug, and close the system valve to ensure that no water flows
out when disconnecting the hose from the back end of the pool.
6. Remove the original hose from the backflow of the swimming pool, connect it to
the water inlet end of the solar heating panel, put on the stainless steel grommet and
tighten it.
Aluminum feet