10
11
www.Deuba24online.de
www.Deuba24online.de
GENERAL INSTRUCTIONS:
This product may only be installed by qualified
electricians.
WARNING:
-Make sure that the power is off before doing any
installation or maintenance work.
-Do not attach the appliance to an inflammable
surface.
-Although the appliance is waterproof ,it should
not be subjected to a stream of water.
-Do not use more powerful bulbs than indicated
on the lamp socket or box.
Note:
The lantern socket is suitable for lamps with E27
with max. 60W. Be sure to use them and replace
them accordingly.
MAINTENANCE AND CARE:
Do not use a hose to clean the lamps .Wipe them
with a damp cloth.
Repairs must be done only by professionals.
STANDARD LAMPS:
1- Use the base of the lamp as a gauge for
marking the three holes on the base.
2- Drill holes ,insert wall plugs and attach the
pedestal temporarily to the concrete base ,using
the screws supplied with the lamp (see figure 1).
Make sure that at least 30 centimetres of the
power cable underneath the appliance.
3- Attach the central shaft securely to the
pedestal of the lamp using the screws provided
,after inserting a power cable with the
characteristics shown in figure 1 .Make sure that
the cable is long enough (see figure 2).
4- Now you can attach the upper shaft to the
central shaft using the special screws (see figure
3).
5- Attach the upper hexagonal block and screw it
in place as shown in figure 4,making sure that at
least 15 centimetres of power cable protrude at
the top.
Figure 1
2
1
MIDDLE
SECTION
ELECTRIC
CONDUCTOR
Figure 2
1
2
3
UPPER
SECTION
CONDUCTOR
MIDDLE
SECTION
Figure 3
6- Then, attach the arms with the lamp housings
to the hexagonal block using the screws provided
and connect the electrical conductors in the base
cavity (see figure 5).
internal metal surface .Then close the top with
the covering and lid.
8- Connect the cable protruding from the base to
power cable ,using a screw terminal (see figure 6)
,taking care to connect the earthing conductor at
the base of the standard lamp.
9- Bolt the pedestal of the lamp to the concrete
base and tighten the blots.
10- See below instructions for connecting the
coloured wires.
Connect the conductors from the lamp to the
main line with screw terminals taking care to :
A) connect the green/yellow conductor (earth
wire) of the power supply.
B) Connect the blue wire from the lamp to the
blue (neutral) wire of the power supply.
C) Connect the brown wire from the lamp to the
brown ,black or red wire of the power supply.
7- Connect the conductors from the lamp to the
power cable with a screw terminal ,as shown in
figure 5.Attach the earthing conductor to the
Disposal:
Once item end-of-life, please dispose valuable raw materials for a proper recycling. If you are
not sure how to handle it in a correct way please contact your local disposal or recycling centers
for advice.
1
UPPER
SECTION
Figure 4
1
2
COVER
AND JOINT
SCREW
TERMINAL
Figure 5
1
2
3
CONDUCTOR
SCREW
TERMINAL
BASE
Figure 6