![background image](http://html1.mh-extra.com/html/monzana/102753/102753_instructions-manual_1831224018.webp)
18
COMMISSIONING
Oiling
CAUTION: Only use special compressed air oil. Do
not use any other type of oil as this could lead to
damage to the device.
lubricator, the device must be regularly lubricated
with special hydraulic oil.
For low-level use, lubricate once a day; for heavy
use, lubricate twice a day. Pour 2-3 drops of
lubricant directly into the air intake of the nail
unit. If too much oil is used, it will collect in the
device and be expelled in the exhaust.
Do not use detergent oil, WD-40, gear oil, engine
designed as a hydraulic oil. Unsuitable oils will
cause increased wear of the seals and O-rings,
repairs.
2-3 drops of
specially
compressed ail oil
Set air pressure between 70 PSI and 110 PSI,
depending on the staple length and hardness of
the workpiece. The best pressure is the lowest at
which you can work with successfully. Working
with a greater air pressure than you need puts
unnecessary demands on the device. Never
exceed 110 PSI.
70PSI Minimum
110PSI Minimum
110 PSI ein, entsprechend der Nagellänge und
der Härte des Werkstücks. Der beste Druck ist
der niedrigste Druck bei dem Sie erfolgreich
arbeiten können. Mit einem höheren als dem
PSI.
gases as a propellant. Flammable gases and other
cylinder gases are dangerous and may cause the
equipment to explode.
WARNING: Never connect the unit with a
compressed air source that can exceed 200 PSI.
equipment explosion, and injury.
WARNING: Do not exceed the pressure indicated
on the device. Before using the device, check
that the correct air pressure range is set. Make
sure that the pressure gauge is working and
check it twice daily. Devices, if they are not used
explosion and injury.
only use suitable air hoses that meet the
following requirements:
•
•
Minimum inner diameter: 0.64cm
•
Maximum length: 30m
www.DeubaXXL.de
Содержание 102753
Страница 51: ...51 www DeubaXXL de ...