Monuments Edge Series, Инструкция по установке и эксплуатации

Страница: 25 / 43

25
EN
Dear customer
You have purchased a high-quality technical
device with which you will have years of sau-
na fun. This sauna heater was designed and
inspected according to the current European
safety standards and manufactured at the
factory in accordance with the quality ma-
nagement standard DIN EN ISO 9001:2008.
This detailed installation and operation ma-
nual has been prepared for your information.
Please observe in particular the important
notes and the information on electrical
connection.
We wish you exhilarating recreational expe-
rience and lots of fun with your sauna!
Intended use
This sauna heater is exclusively intended
for the heating of sauna cabins in combina-
tion with an appropriate control unit.
Any other use over and above the intended
purpose is not considered as appropriate
use! Compliance of the standard operation,
maintenance and repair conditions is also
an element of appropriate use.
The manufacturer cannot be held liable for
deviating, unauthorized alterations and any
resulting damages: the initiator of these
changes bears the full risk.
General information
Please check whether the unit has arrived
in perfect condition. Any transport damages
should be immediately reported to the freight
forwarder delivering the goods or you should
contact the company that shipped the goods.
Please note that you will only be able to
achieve an optimum sauna climate if the
cabin with its air intake and ventilation, the
sauna heater and the control unit are aligned
to each other.
Please observe the information and stipula-
tions made by your sauna supplier.
Sauna heaters heat up your sauna cabin
using heated convective air. Here, fresh air
is drawn in from the air intake which, when
heated, rises upwards (convection) and is
then circulated within the cabin. Part of the
used air is pushed out through the vent in the
cabin. This creates a typical sauna climate
which can achieve temperatures of approx.
110°C measured directly under the ceiling
of your sauna, dropping in temperature to
approx. 30-40°C towards the floor. It is the -
refore not unusual to measure temperatures
of 110°C on the temperature sensor hanging
over the heater, whilst the thermometer han-
ging on the sauna wall, approx. 20-25 cm un-
der the cabin ceiling, only indicates 85°C. The
bathing temperature generally lies between
80°C and 90°C in the area of the upper bench
when the temperature is set to maximum.
Please note that the highest temperatures
are always generated over the sauna heater
and that the temperature sensor and the
safety limiter must be mounted there in
accordance with the control unit installation
instructions.
When heating up for the first time, you may
notice a slight smell caused by evaporating
lubricants used in production processes.
Please ventilate your cabin before beginning
your sauna bath.