General Information & Safety
Page 4
XG0219 - 080421
Congratulations on the purchase of a
Congratulations on the purchase of a
Montigo Fireplace
Montigo Fireplace
This product must be installed by a qualified installer.
• Do not install this model inside your home or any other confined space.
• See location section for minimum outdoor space requirements.
• Only burn this model with the glass front installed including the safety
screen protecting you from accidental contact with the hot glass.
• Please unpack the fireplace and count all of the parts before you start
installing.
• Make sure you inspected this fireplace for possible freight damage as
well as scratches to the front portion of this fireplace. To clean the front
portion use a mild cleaning agent and wipe the stainless steel in the
direction of the grain.
• Build a structure of your choice around the fireplace with wood, steel
studs or any other conventional building materials.
• Select a location that will limit the exposure to strong winds.
• Follow the location section guidelines for installations in smaller spaces
Gas line and connection:
• Have a certified gas fitter install a gas line that will supply the required
level of gas to the left side of this fireplace with an accessible gas
service shut off valve. Gas supply as per the rating and pressures
shown in section "Gas Connection"
Getting Started
Electrical:
• The unit has built in fans to force out all of the heat right above the
glass window. Due to the glass window, this model is less sensitive to
moderate wind conditions.
• Select a location where you would like to install the control box that will
control this fireplace.
• Install a 120 Volt cable from this box to the fireplace as per the electrical
diagram.
• Plug the power cable from your control box into a power supply that is
protected by a ground fault Breaker ( GFCI )
• The toggle switch that is located on the left side of the control box will
start the blowers running.
• Safety switches in the bottom of the fireplace will sense the moving air
stream and activate the gas burner system.
• The electrical installation must comply with applicable standards.
Ensure that all power to the appliance is off at the electrical breaker
or fuse before beginning installation. Ensure gas is turned off at the
shutoff valve before beginning installation.
During unpacking and assembly we recommended you wear work
gloves and safety glasses for your protection. Although we make every
effort to make the assembly process as problem free and safe as
possible, it is characteristic of fabricated steel parts that the edges and
corners might be sharp and could cause cuts if handled incorrectly.
WARNING
CAUTION
