Page 18
H42DF-O Outdoor Gas Fireplace
Part No. XG0149
Operation - Model H42DF-O
H42DF-O
WARNING:
If you do not follow these instructions exactly, a fire or explosion may
result causing property damage, personal injury or loss of life.
If you cannot reach your gas supplier, call the Fire
Q
Department.
C.
Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by hand,
don't try to repair it, call a qualified service technician. Force
or attempt to repair may result in a fire or explosion.
D.
Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system, and
any gas control which has been under water.
A.
This appliance has a pilot which must be lighted by hand.
When lighting the pilot, follow these instructions exactly.
B. BEFORE LIGHTING
smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas is
heavier than air and will settle on the floor.
What To Do If You Smell Gas:
Do not try to light any appliance.
Q
Do not touch any electrical switch; do not use any phone
Q
in your building.
Immediately call your gas supplier from a neighbour's
Q
phone. Follow the gas supplier's instructions.
To Turn Off Gas To Appliance:
3. Push in gas control knob slightly and turn
clockwise to
"Off". Do not force.
4. Replace the lower Horizontal access panel
1. Turn off remote switch.
2. Remove the lower Horizontal access panel
1.
STOP!
Read the safety information above on this label.
2.
Remove the lower Horizontal access panel
3.
Push in gas control knob and turn clockwise
to "OFF."
4.
Wait five (5) minutes to clear out any gas. Smell for gas,
including near the floor. If you then smell gas,
STOP!
Follow
"B" in the safety information above on this label. If you don't
smell gas, go to the next step.
5.
Locate pilot burner
(See illustration at right.)
and follow steps
below.
6.
Turn knob on gas control counter clockwise
to
"PILOT."
7.
Push in gas control knob completely and hold. Light with Piezo
Igniter button. Continue to hold the control knob in for about
(1) minute after the pilot is lit. Release the knob and it will pop
back up. Pilot should remain lit. If it goes out repeat steps 3
through 8.
If knob does not pop up when released. Stop and
Q
immediately call your service technician or gas
supplier.
If the pilot will not stay lit after several
Q
tries, turn the gas control knob to
"OFF" and call your service technician
or gas supplier.
8.
Push in gas control knob and turn counter-
clockwise
to "ON."
9.
Replace the lower Horizontal access
panel
10.
Turn on remote switch to ignite fire.
Lighting Instructions:
with Continuous Pilot
For Your Safety - READ BEFORE LIGHTING:
NOTE:
Gas control knob cannot be turned from
"PILOT" to "OFF" unless knob is pushed
in slightly. Do not force.
