XG0222
30
Installation
Removing the Screen
Follow the steps below to remove, or install the fireplace screen and
door.
Before beginning any screen or glass removal, make sure that the
unit has not been in operation and that it is at room temperature.
Step 1:
Locate the three tabs at the base of the screen.
Step 2:
Lift out the Retaining Tabs and screen.
Pull the bottom of the screen outward, then slide out the screen from
the frame.
Store in a safe place. The Screen is very fragile and can be easily torn,
dented or deformed. Refer to Figure 20.b below.
Reinstalling the Screen
Follow the two previous steps to re-install the fireplace window.
Section 8: Removing & Installing the Screen / Door
Any safety screen, guard, or barrier removed for servicing an
appliance, must be replaced prior to operating the appliance
Figure 20.
Locate the three tabs at the base of the screen
Figure 20.b
Lift out the Retaining Tabs and screen
NOTICE
STEP 1:
Remove lower valve blinds and screen setting bar.
STEP 1:
The upper frame of the
door is pushed into the
top channel before the
bottom is pushed into
place.
STEP 2:
Ensure the tool is firmly
in the lower end of the
slot, (as shown), Then
pull toward you, door will
unlatch, repeat for other
buckles.
STEP 2:
Buckles are locked into
place by pulling out and
up, latch will pop into
place.
STEP 3:
With glass lifting tool (if
needed), pull the top of
the door towards you,
then lift the door up
and out of the fireplace
frame. Store in a safe
place.
Removing the door
The Distinction doors are removed in a few simple steps. Follow these
steps below to unlatch the door buckles and remove the door.
Reinstalling the door
NOTE: Make sure the top and base of the door slips into the narrow
channel in the frame to ensure proper placement.
Figure 21.b
Installing the door
Figure 21.d
Pull door latches
Figure 21.d
Pull door latches
Figure 21.e
Lift the door
