Montigo CabanaFire PL42VO, Инструкция по установке и обслуживанию

Страница: 37 / 46

Page 37
XG0219 - 170829
Operation
Remote (RXM5010VO)
Battery Life
Life expectancy is based on usage.
Check and replace all batteries:
• Annually.
• When operating range becomes reduced.
• When transmissions are not received by the remote receiver.
• If the hand held transmitter batteries measure less than 5.0
volts.
Troubleshooting
If you encounter problems with your fireplace system, the problem may be
with the fireplace itself or it could be with the remote control. Review the
fireplace manual to make sure all connections are properly made. Then
check the operation of this remote in the following manner:
1. Be sure the transmitter's batteries are properly installed and that the
battery output is 5.0 V or more.
2. Ensure the receiver is connected to a 110-120 VAC power source.
3. Check to make sure the transmitter is communicating with the
receiver
• If the receiver beeps when the MODE button is depressed on
the transmitter they are communicating.
• If the receiver does not beep when the MODE/SET button is
depressed on the transmitter, you will need to teach the receiver
the code of the transmitter. This is done by pressing and
releasing the LEARN button on the receiver and depressing the
MODE/SET button on the transmitter. A change in the beeping
pattern at the receiver indicates the transmitter's code has been
programmed into the receiver.
4. Make sure the transmitter is within 15 to 20 feet of the receiver.
5. Positioning of the receiver is important. If the receiver is enclosed in
a metal surround the operation of the receiver may be affected as
noted below. Reposition the receiver to improve operating range. It is
suggested that a heat shield be installed to protect the receiver from
extreme heat. If the receiver is enclosed in a metal surround this can:
• Cause the RF signal to get lost and interrupt communication
with the receiver.
• Cause the working distance to be shorter than normal.
Note: A receiver located in an area where ambient temperature inside the
case exceeds 130°F will trigger the THERMO-SAFETY feature requiring
repositioning of the receiver to stop the warning beeps and reset the
receiver's operation.
FCC REQUIREMENTS
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE
FOR ANY RADIO OR TV INTERFERENCE CAUSED
BY UNAUTHORIZED MODIFICATIONS TO THE
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE
USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
Battery Operated Device
Read the battery instructions before installing them into the system.
Do not expose any battery, or its holder, or a device in which
batteries are involved, to a working temperature of the device to
which the batteries are connected is reported to be greater than
54C / 129F. In bad cases, overheating can cause hydrogen gas
and danger of explosion.
Please note leaving batteries installed in the remote for an
extended period when not in use may cause the batteries to drain
and/or corrode.
WARNING
NOTICE