Page 29
XG0508-
150204.1
I-Series Indoor Gas Fireplace
Installation
11). Place the master override switch in the OFF position. Until
the remote is synced to the control board, this switch acts as a
master. If you apply gas and power to the unit while this switch is
in the ON position, it will initiate lighting.
Figure 59 Sec.4
13). The Front trim can now be installed. Catch the bottom flange
of the front plate over the bottom flange of the rear plate. Then
slide forward to secure the magnets.
Figure 60 Sec.4
14) Watch the front plate does not catch on the nutsert at the
lower left of the fireplace.
15). Trim installation completed. Make sure it is securely in place.
Figure 61 Sec.4
Figure 62 Sec.4
12). At this stage it is easiest to install the batteries. See section
on battery installation and replacement.
Figure 63 Sec.4
Front Plate
bottom Flange
Rear Plate
bottom Flange
