Page 27
XG0526-151109.2
I-Series Indoor Gas Fireplace
Installation
11). Place the Zip Strap through the hole in the Plastic Stick on
Retainer on the back of the Rear Faceplate. Zip the wires together
in one tidy package as shown.
Figure 57 Sec.4
12). Place the master override switch in the OFF position. Until
the remote is synced to the control board, this switch acts as a
master. If you apply gas and power to the unit while this switch is
in the ON position, it will initiate lighting.
Figure 58 Sec.4
14). The Front trim can now be installed. It has two fasteners at
the bottom which must be engaged in the bottom right and left
of the Front Faceplate. Magnets hold it at the top right and left.
Figure 59 Sec.4
15) Hooks are used to secure the Front Faceplate at the bottom
left and right.
16). Trim installation completed.
Figure 60 Sec.4
Figure 61 Sec.4
(Unpainted shown for illustration)
13). At this stage it is easiest to install the batteries. See section
on battery installation and replacement.
10) Connect the Plug to the appropriate terminal on the Control
Panel.
Figure 62 Sec.4
