11
1
•
888
•
557
•
3848
Wards.com
Water Drainage
10
Manual Drainage
When “FL” is illuminated on the control panel, water must be drained from the unit
before operation can resume. To drain water, follow these steps:
1. Power OFF the unit and unplug from electrical source.
2. Put a pan under the water outlet located on the back of the unit.
3. Unscrew the drain cap and pull out water plug.
4. Tilt the unit slightly backwards to ensure complete drainage.
5. After water is fully drained, insert water plug and screw on the drain cap.
6. Plug the unit back in and power ON.
Cleaning and Care
To keep your Portable Air Conditioner in good working order, it is recommended that
you clean the frames and filters every two weeks.
1. Power OFF the unit and unplug from electrical source.
2. Place finger on the indentation of the filter frame and gently pull away from unit.
3. Remove filter on the side of the unit by sliding it towards the rear and out.
4. Remove filters on the back of the unit by sliding to the right and out.
5. Wash frames and filters with warm sudsy water and rinse thoroughly. Dry
frames with soft cloth and let filters dry in the sun.
Operating Instructions
(cont’d)
To use the remote control, you must be within 20 feet of the unit with a clear line of
sight. Remove batteries when control is not in use for long periods of time.
1. Power button:
Turns unit ON/OFF.
2. Celsius/Fahrenheit button:
Switches temperature readout between degree
types.
3. Fan button:
Turns the fan on or off.
4. Cool button:
Starts cooling mode.
5. Auto button:
Automatically switch to cooling when the ambient temperature is
above 77
°
F and to fan mode when below.
6. Up/Down buttons
: Increases/decreases temperature setting by one degree for
each push of the button.
7. High button:
Increases fan speed.
8. Low button:
Decreases fan speed.
9. Max Cool button:
Switches fan to high speed during cooling mode. To lower
fan speed, switch off Max Cool.
10. Sleep button:
Starts sleep function, wherein the temperature will increase one
degree after two hours and then another degree after another two hours. After
the last increase the temperature will remain unchanged and the fan speed will
change to low.
11. Timer button:
When AC is off, press to program timed start. When AC is on,
press to program timed shutdown.
1
2
3
4
5
6
7
8
9
10
11
Remote Control
