ETL model no. :5VBR60
Hang assembled fan from the mounting bracket
installed to ceiling in previous step. Make sure the
fan is hanging straight. Rotate fan until the tab on
the Mounting bracket engages the slot on the
Downrod Ball. This must be done to prevent the fan
body from rotating when the blades are in motion.
12
Install the keeper to the pin.
Tighten the 2 set screws on the yoke
once the downrod is in place.
10
11
Place the canopy on the downrod.
7
Insert downrod into yoke on top
of the Fan body. Align the hole in
the downrod with the hole in the
yoke. Insert the pin through the
yoke and downrod until the point
appears on the other side.
9
Lift canopy allowing the 2 studs to
protrude through the canopy and
install the knurled nuts as shown.
Tighten the knurled nuts securely.
17
Thread the leadwires and safety
cable through the downrod.
8
For Canadian installation the safety cable must be
installed into the house structure beams using the
3” lag screws provided. Make sure that when the
safety cable is fully extended the leadwires are
longer than the cable and no stress is placed on
the leadwires.
13
CCaannaaddiiaann m
moouunnttiinngg oonnllyy
Safety Cable
Lag Screw
Lag Screw
Safety Cable
Washer
Lock Washer
Make sure the studs protruding from the
bottom of the Mounting bracket are
installed with threads all the way through
the bracket.
14
Install 3 screws with fiber washers
per blade and tighten securely.
Repeat for all 5 blades.
18
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the
wire connections, the wires should be spread
apart with the grounded conductor and the
equipment-grounding conductor on one side of
the outlet box and ungrounded conductor on
the other side of the outlet box.
16
15
House
Fan
Black
White
Green
Black
White
Green(downrod)
Green(Bracket)
Make sure that all exposed wiring is
secured inside wire nuts. Note: Wires from
house may vary in color and may not
include ground wire. After wiring is com-
pleted, gently push wires into junction box
with wire nuts pointing upward.
