Tighen set screws and lock nuts to
secure downrod in place.
Loosen 2 set screws with lock nuts in
yoke till you can not feel them on
inside of yoke.
Loosen screw, remove cross pin, and
remove downrod ball. Save for re-
installation.
Remove keeper from pin and then
pin from yoke and save.
9
10
16
18
Lift mounting neck to mounting Plate
and align screws.
7
Secure mounting neck to the mount-
ing plate with four screws to become
a complete mounting bracket.
8
Insert downrod into yoke on top of
the Fan Body. Align the hole in the
Downrod with the hole in the Yoke.
Insert the Pin through the Yoke and
Downrod until the point appears on
the other side. Install the Keeper
Pin
17
Check the motor for plastic shipping
stabilizers and remove if present.
11
Loosen 3 screws with key hole slots
and remove the 1 screw without key
slot. Save screw removed. Remove
lower housing.
12
Take lower housing and place over
the 3 screws and twist direction of
arrows to hold in place. Replace
screw removed and tighten all 4
screws securely.
14
Install 4 x 25 watt candelabra bulbs.
15
Place upper porcelain over fan body.
13
