Remove finial nut, hex nut and rub-
ber washer from the the fitter. Keep
them for later use.
22
Attach decorative medallion to blade.
Install the blade with 4 screws in
hardware pack, tighten securely.
Repeat this procedure 4 more times.
19
Remove 2 cardboards pre-installed to
the fan body. Attach blade assembly
to the motor and tighten screws
securely. Repeat this process four
more times.
20
Remove 1 screw and loosen the
other 2 screws. Save screw.
21
Align keyslot holes of the light kit
plate and twist to lock. Add the
screw removed from step 21.
Tighten securely.
24
25
Install 3x40 watt candelabra base bulbs.
Bulbs included.
WaRnInG
:
over lamp-
ing the fan will result in the fan
lights shutting down till the proper
wattage of bulbs are installed. Reset
the lights by turning off the wall
switch, bracker, or by remote.
Replace bulbs with the correct
wattage bulbs, turn the power on.
Attach the glass to the fan. Install
the rubber washer and hex nut which
removed from step 22 to the thread
rod and secure the glass
26
Connect white wire from fan to
white wire from light fixture.
Then plug blue wire from fan to
black wire from light fixture.
23
Install wall control unit to outlet box
using machine screws provided.
30
WALL MOUNT INSTALL
27
Install the decorative finial nut to
secure the glass in place.
Remove battery cover. Install 12V battery into
wall remote. Duracell MN21 / Eveready A23 /
GP 23A all 12V.Attach cover of remote by plac-
ing over buttons and snap the battery cover in
place.
Place face plate over battery compartment and
buttons. Place remote over 2 pins on front
cover. Attach cover of remote by placing over 4
pins and snapping into place.
29
28
HAND HELD INSTALL
