© Copyright 2001, Monte Carlo Fan Co.,REV.0, 4/30/01
Page 4 – 5KC48/5SG52-English CUL
Note:
After installation, please refer to operation, maintenance and troubleshooting sections in this manual.
If your fan is packaged with a light kit or if you wish to install a separately purchased light kit,
please refer to the insert sheet titled:
L
IGHT
K
IT
I
NSTALLATION
I
NSTALLATION
WIRING OPTION WITH WALL SPEED CONTROL
Wall
control
Light Switch
Fan Switch
8
For control of fan and optional light from
wall location, follow diagram above.
NOTE: A professional electrician is
recommended for this type of installation.
7
*ATTACH BLUE WIRE
ONLY IF ATTACHING
LIGHT KIT WITH FAN
*
Secure with
twist-lock wire
connectors
(included)
For pullchain controls, follow diagram above.
Make sure that all exposed wiring is secured
inside wire nuts. Note: Wires from house may
vary in color and may not include ground wire.
After wiring is conplete, gently push
wires into junction box with wire nuts
pointing upward. Refer to point 3 of
safety tips.
STANDARD WIRING OPTION
9
Raise the canopy up and align the two
holes in the canopy with the two holes in
the hanger bracket. Secure with two 5/
32 x 1/2" screws provided.
10
Fiber
Washers
Attach blade brackets to blades using
the blade bracket screws and washers
provided.
11
12
Remove plastic shipping stabilizer tabs from
motor, if present. The screws, washers and
motor pads are pre-installed to the blade
holders. Attach blade assembly to motor by
tightening first screw one turn, then
tighten second screw securely. Then, go
back and tighten first screw securely.
Shipping
Stabilizer
Tab
13
After attaching blade; reinstall the
switch housing using the three screws
previously removed.
To gain access to the blade bracket
attachment holes remove the switch
housing cover by unscrewing the three
screws. Gently slide the cover off .
