© 2013 Monte Carlo Fan Company
8/13/2013
5
Check the motor for shipping stabiliz-
ers and remove if present. Attach
blades using screws and washers in
hardware pak. Tighten screws se-
curely.
26
Remove side covers from canopy exposing
4 holes. 2 closed holes and 2 open “L”
shape holes and then Pass leadwires and
safety cable through the canopy.
19
“L” shape
slots
Install rubber pad between fan
body and canopy.
18
Remove the all thread studs from the
lower part of the mounting bracket. Hang
fan from mounting bracket by the
hands free hook into a closed hole on
the edge of the Canopy.
Note
: For
Canadian mounting refer to Step #12.
21
Hands free hook
Place canopy over fan body align-
ing holes.
Replace the 3 screws removed and
tighten securely. Check motor for
shipping stabilizers and remove if
present.
20
Take 4 screws from hardware pack
and install one on each side of
bracket to match the L slot screw
holes in canopy. Keep 2 screws for
later use.
22
Make wire connections to power source using wire nuts
provided. Make sure that no filiments are outside of
the wirenut. After making the wire connections, the
wires should be spread apart with the grounded con-
ductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on the
other side of the outlet box.
24
Lift fan to mounting bracket, aligning the “L”
shape holes with the screws on the mounting
bracket. Turn the fan clockwise to lock in
position. Install the other 2 screws included
in hardware bag and tighten all 4 securely.
25
Make wiring connections as indicated
above. Connect black and blue wire from
fan to Black or (Hot) wire from house.
Connect White wire from Fan to White
(Neutral) wire from house. Connect
Ground leads from mounting bracket and
downrod to Ground lead from house.
Refer to Safety Tips section of manual.
23
