Insert downrod into motor yoke.
Next,insert clevis pin through yoke
and downrod and secure with cotter
pin.
Carefully lift fan assembly onto
mounting bracket. Rotate fan so that
the notch on the ball engages the
ridge in the mounting bracket. This
will allow hands-free wiring.
10
7
8
Tighten both yoke set screws to fur-
ther secure downrod.
Remove the shipping stabilizers
and throw discard.
9
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the
wire connections, the wires should be spread
apart with the grounded conductor and the
equipment-grounding conductor on one side of
the outlet box and ungrounded conductor on
the other side of the outlet box.
12
For Canadian installation and for USA fan and
light kit combinations over 35 lbs, in both flush
and downrod mode the safety cable must be
installed into the house structure beams using
the 3” lag screws provided. Make sure that
when the safety cable is fully extended the
leadwires are longer than the cable and no
stress is placed on the leadwires.
11
Safety cable installation
Safety Cable
Lag Screw
Make sure that all
exposed wiring is secured inside wire
nuts. Note: Wires from house may
vary in color and may not include
ground wire. After wiring is conplete,
gently push wires into junction box
with wire nuts pointing upward.
Refer to point 3 of safety tips.
13
House
Fan
Black
White
Green
Black
White
Green(downrod)
Green(Bracket)
Place blade onto blade holder.
Install 3 screws and washers per
blade and tighten securely. Repeat
for all 5 blades
17
Raise the canopy up and align the
two holes in the canopy with the two
holes in the hanger bracket. Secure
with two screws provided.
14
Attach blade assembly to motor
using the motor screws and washers
provided. Tighten screws securely.
18
Place the gasket onto the blade
bracket as shown above.
15
Place blade onto blade bracket with
gasket.
16
