7/1/2013
© 2013 Monte Carlo Fan Company
4
10
Install keeper pin.
11
Tighten the 2 set screws on
the yoke, once the down rod
is in place.
12
Loosen one and remove one
preassembled screws from
m o u n t i n g b ra c k e t . S a v e
screw for later use.
13
Hang assembled fan from the mounting
bracket installed to ceiling in previous
step. Make sure the fan is hanging
straight. Rotate fan until the tab on the
Mounting bracket engages the slot on
the Downrod Ball. This must be done to
prevent the fan body from rotating when
the blades are in motion.
15
Connect black and blue wire from fan to
Black or (Hot) wire from house. Connect
White wire from Fan to White (Neutral)
wire from house. Connect Ground leads
from mounting bracket and downrod
to Ground lead from house. Refer to
Safety Tips section of manual.
16
Make wire connections to power source
using wire nuts provided. Make sure that
no filiments are outside of the wirenut. After
making the wire connections, the wires should
be spread apart with the grounded conductor
and the equipment-grounding conductor on
one side of the outlet box and ungrounded
conductor on the other side of the outlet box.
The splices after being made should be turned
upward and pushed carefully up into the outlet
box.
17
18
Lift canopy up, aligning its keyhole
slot with the preassembled screw
on mounting bracket and twist till
lock. Install the screw removed
in step 12. Tighten all screws
securely.
Attached canopy bottom cap
onto canopy by aligning its
notches with the screws on
mounting bracket and twist
clockwise till tight.
Supply
circuit
For Canadian installation and for USA fan and light
kit combinations over 35 lbs, in both flush and
downrod mode the safety cable must be installed
into the house structure beams using the 3” lag
screws,washers, and lock washers. provided. Make
sure that when the safety cable is fully extended
the leadwires are longer than the cable and no
stress is placed on the leadwires.
Note
: If Installing The Secondary Support Safety
Cable in the U.S., Do Not Remove Knockouts In The
Outlet Box.
14
Lag screw
Safety cable
Washer
Lock washer
Lag screw
Safety cable
Safety cable installation
