7/1/2013
© 2013 Monte Carlo Fan Company
3
1
Before you begin installing the fan, Switch
power off at Service panel and lock service
disconnecting means to prevent power
from being switched on accidentally. When
the service disconnecting means cannot
be locked, securely fasten a prominent
warning device, such as a tag, to the
service panel.
2
Before installing this fan make sure the
outlet box is properly installed to the house
structure. To reduce the risk of fire, electric
shock, or personal injury, mount to outlet
box or supporting system acceptable for fan
support.
(Mounting must support at least 35 lbs.)
3
Use metal outlet box suitable for fan support
and use only the screws provided with the
outlet box (must support 35 lbs). Before
attaching fan to outlet box, ensure the outlet
box is securely fastened by at least two points
to a structural ceiling member ( a loose box
will cause the fan to wobble). Remove the
two outlet box screws provided with the box,
aligning the holes of the mounting bracket
with the holes of the outlet box. Re-install the
2 outlet box screws securely.
4
Loosen 2 screws on yoke to
allow down rod to slip into
yoke.
5
6
Place canopy over downrod.
Remove keeper pin and cross
pin from yoke, and save for
later use.
8
7
Thread the leadwires and
safety cable through the
downrod.
Place canopy bottom cap over
downrod and then place yoke
cover over downrod as shown.
9
Insert downrod into the yoke on top of
fan body. Align the hole in the downrod
with the hole in the yoke. Insert cross
pin through yoke and downrod until
point appears on the other side.
