Monte Carlo Fan Company 5CQ52 Series, Руководство пользователя и инструкция по установке

Страница: 4 / 9

2/6/2012 © 2011 Monte Carlo Fan Company
4
10
Install keeper pin.
11
Tighten 2 set screws on yoke
once the down rod is in place.
13
Hang assembled fan from the mounting
bracket installed to ceiling in previous
step. Make sure the fan is hanging
straight. Rotate fan until the tab on
the Mounting bracket engages the slot
on the Downrod Ball. This must be
done to prevent the fan body from
rotating when the blades are in
motion.
15
Make wiring connections as indicated
above. Connect black and blue wire from
fan to Black or (Hot) wire from house.
Connect White wire from Fan to White
(Neutral) wire from house. Connect
Ground leads from mounting bracket and
downrod to Ground lead from house. Refer
to Safety Tips section of manual.
16
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the wire
connections, the wires should be spread apart
with the grounded conductor and the equipment-
grounding conductor on one side of the outlet
box and ungrounded conductor on the other side
of the outlet box. The splices after being made
should be turned upward and pushed carefully up
into the outlet box.
For Canadian installation and for USA fan and light
kit combinations over 35 lbs, in both flush and
downrod mode the safety cable must be installed
into the house structure beams using the 3” lag
screws,washers, and lock washers. provided. Make
sure that when the safety cable is fully extended
the leadwires are longer than the cable and no
stress is placed on the leadwires.
14
Lag screw
Safety cable
Washer
Lock washer
Lag screw
Safety cable
Safety cable installation
17
Lift canopy up, aligning its keyhole
slots with the preassembled screw on
mounting bracket and twist clockwise till
lock. Install the screw removed in step
12. Tighten all screws securely.
12
L o o s e n t w o p r e a s s e m b l e d
screws across from each other
corresponding to the open slotted
holes on the canopy upper rim and
remove the other two screws from
mounting bracket. Keep screws for
later use.
G o t o s t e p 2 7 t o
finish installation
Supply
circuit