4
© 2014 Monte Carlo Fan Company
11/1/2014
7
8
9
10
11
12
Install ball end of downrod into mounting
bracket opening. Align (engage) slot on
ball with tab on mounting bracket.
Warning:
Failure to align slot on ball with
tab may result in serious injury.
Important
: If using the angle mount,
make sure open end of mounting bracket
is installed facing the higher point of the
ceiling and make sure the ceiling angle is
not steeper
than 30º.
For Canadian installation and for USA fan
and light kit combinations over 35 lbs, in
both flush and downrod modes the safety
cable must be installed into the house
structure beams using 3” lag screws,
washers and lock washers provided.
Make sure that when the safety cable is
fully extended the lead wires are longer
than the cable and no stress is placed on
the lead wires.
Note
: If Installing The Secondary Support
Safety Cable in the U.S., Do Not Remove
Knockouts In The Outlet Box.
Set dip switches on the Remote
Transmitter and Remote Receiver to the
same settings. This must be done so the
units will communicate properly. If you
have other fans you can set to control
from one Transmitter by setting
receivers the same as the Transmitter. If
you have more than one fan with remote,
you can set the dip switches to different
positions to have separate control.
Make wire connections using wire connectors
provided as indicated above. White from fan
to White from remote marked N. Blue from fan
to Blue from remote marked For Bottom Light.
Orange from fan to orange from remote
marked For Upper Light. Black from fan to
Black from remote marked L. White from
house to White from remote marked AC N.
Black from house to Black from remote
marked AC L. Connect all green grounded
wires to Grounded wire from House. Make
sure that no filaments are outside of the wire
connectors.
Insert the remote receiver into mounting
bracket.
Lift Canopy, allowing the 2 studs to
protrude through the canopy.
Install knurled nuts provided and tighten
the knurled nuts securely. The canopy
should adjust for any irregularity in the
ceiling or outlet box.
Make sure the studs protruding from the
bottom of the Mounting bracket are
installed with threads all the way through
the bracket.
Align the holes of blade bracket, blade
and the bottom plate of blade bracket.
Install blade bracket with blade by 4 blade
screws provided. Tighten screws securely.
Repeat this process for remaining blades.
Note
: Make sure the side with a label “This
side up” is installed upward.
SAFETY CABLE INSTALLATION
Dip switches
Lag screw
Safety cable
Washer
Lock washer
Stud
ON
Tab
Slot
Wall
switch
White
White
Blue
Black
Black
Receiver
Ground/Green
Black
(Live)
White
(Natural)
Power
source
Blade bracket
Blade
Bottom plate
Orange
