Monte Carlo Fan Company 3VER56XXD Series, Руководство пользователя и инструкция по установке

Страница: 3 / 9

3
© 2011 Monte Carlo Fan Company
3/5/2012
1 2 3
4 5 6
ON
OFF
ON
OFF
Before you begin installing the fan, Switch
power off at Service panel and lock
service disconnecting means to prevent
power from being switched on
accidentally. When the service
disconnecting means cannot be locked,
securely fasten a warning device, such
as a tag, to the service panel.
Before installing this fan make sure the
outlet box is properly installed to the
house structure. To reduce the risk of
fire, electric shock, or personal injury,
mount to outlet box or supporting system
acceptable for fan support.
(Mounting must support at least 35 lbs.)
Use metal outlet box suitable for fan
support and use only the screws provided
with the outlet box (must support 35
lbs). Before attaching fan to outlet box,
ensure the outlet box is securely fastened
by at least two points to a structural
ceiling member ( a loose box will cause
the fan to wobble). Remove the two outlet
box screws provided with the box,
aligning the holes of the mounting
bracket with the holes of the outlet box.
Re-install the 2 outlet box screws
securely.
Remove preassembled cross pin and
keeper pin from motor housing yoke at
top of motor assembly and partially
loosen downrod set screws.
Place downrod over canopy, canopy
bottom cap and yoke cover. Thread lead
wires and safety cable from motor
assembly through downrod.
Slip downrod into motor housing yoke,
align holes and re-install cross pin and
keeper pin. Re-tighten downrod set
screws on motor housing yoke.
Place yoke cover to motor assembly by
inserting the alignment post on yoke
cover into the hole on top housing.
Yoke cover
Canopy bottom
cap
Canopy
Downrod
Alignment post
Hole
Mounting bracket