5
© 2019 Monte Carlo Fan Company
4/2019
13
14
15
16
17
18
Remove preassembled keeper pin and
cross pin from downrod.
Place downrod over canopy, canopy
bottom cap and yoke cover.
Flip the fan assembly over and carefully
place it on Styrofoam.
Note
: Handle it carefully to avoid damaging
or bending the fan and light fixture.
Partially loosen downrod set screws from
yoke at top of motor assembly.
Thread lead wires and safety cable from
motor assembly through downrod.
Helpful hint:
For easy assembling of the
cross pin on the next installation step.
After slip downrod into the motor yoke,
carefully insert a Phillips screwdriver through
the yoke and downrod (
don’t damage the
lead wires
) as a guide and then push the
cross pin and pull the screwdriver in the
meantime as shown in the inset.
Install ball end of downrod into mounting
bracket opening. Align (engage) slot on
ball with tab on mounting bracket.
Warning:
Failure to align slot on ball with
tab may result in serious injury.
Important
: If using the angle mount,
make sure open end of mounting bracket
is installed facing the higher point of the
ceiling and make sure the ceiling angle is
not steeper than 20º. Longer downrod
may be necessary allowing the fan blades
to rotate without obstructions.
Slip downrod into motor housing yoke,
aligning holes and install cross pin and keeper
pin.
Insert cross pin through yoke and downrod
until point appears on the other side, and
insert keeper pin on cross pin.
Pull the downrod up tight against the cross
pin, and then evenly tighten the downrod set
screws on motor housing yoke.
Place Yoke cover on motor assembly.
Warning
: Cross pin and keeper pin must be
installed securely, failure to install them will
result in serious injury.
Canopy
Downrod
Yoke cover
Canopy
bottom cap
Yoke
Keeper pin
Cross pin
Downrod
Yoke cover
Set screws
Canopy
Canopy bottom cap
Downrod
Slot
Keeper pin
Cross pin
Downrod
Set screw
Yoke
1
2
Cross pin
Screwdriver
2
1
Tab
Содержание 3STR60
Страница 10: ...May 2019...
