Monte Carlo Fan Company 3STMSM60 Series, Руководство пользователя и инструкция по установке

Страница: 5 / 11

5
11 12 13
14 15 16
© 2021 Monte Carlo Fan Collections
8/2021
Make wiring connections using wire connectors provided as indicated above.
Brown wire from fan to Brown wire from receiver marked Motor U.
Gray wire from fan to Gray wire from receiver marked Motor V.
Orange wire from fan to Orange wire from receiver marked Motor W.
White wire from fan marked “For light” to White wire from receiver marked “For light”.
Blue wire from fan marked “For light” to Blue wire from receiver marked “For light”.
White (Neutral) wire from house to White wire from remote marked AC IN N.
Black (Live) wire from house to Black wire from remote marked AC IN L.
Connect all green grounded wires to Grounded wire from House.
Make sure that no filaments are outside of the wire connectors.
Insert the remote receiver into mounting bracket.
After making the wire connections, the wires should be spread apart with the grounded conductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on the other side of the outlet box. The splices after being made should be turned upward and
pushed carefully up into the outlet box.
Place the wi-fi antenna outside canopy and stick/fix it onto ceiling.
Caution
: The installation has to be complete before operate the fan. Receiver has to be used on the fan and cannot be bypassed.
Lift Canopy, allowing the 2 studs to
protrude through the canopy.
Make sure the studs protruding from the
bottom of the Mounting bracket are
installed with threads all the way through
the bracket.
Install knurled nuts provided and tighten
the knurled nuts securely. The canopy
should adjust for any irregularity in the
ceiling or outlet box.
Insert blade into the slot on the flywheel.
Install blade by the screws and rubber
washers provided, aligning each of the
holes as shown and tighten all screws
securely. Repeat this process for
remaining blades.
Loosen 2 and remove 1 preassembled
screw from the plate on motor. Save
screw for later use.
Attach the light pan onto the plate on
motor, Place light pan over the lead wires
from fan, aligning the keyhole slots on the
light plate with the preassembled screws
on the plate. Twist clockwise till lock.
Reinstall the removed screw. Tighten all
screws securely.
Loosen 2 and remove 1 preassembled
screw from the light pan. Save screw.
Install the decorative cap by locating its
groove with the knurled nuts on canopy
and turn clockwise till tight.
Decorative cap
Stud
Blade
Flywheel
Light pan
Plate on
motor