For Canadian installation and for USA fan and light
kit combinations over 35 lbs, in both flush and
downrod mode the safety cable must be installed
into the house structure beams using the 3” lag
screws,washers, and lock washers. provided. Make
sure that when the safety cable is fully extended
the leadwires are longer than the cable and no
stress is placed on the leadwires.
19
Lag screw
Safety cable
Washer
Lock washer
Lag screw
Safety cable
Safety cable installation
22
Make wiring connections as indicated above.
White from fan to white from remote marked
N. Blue from fan to blue from remote marked
light. Black from fan to Black from remote
marked L. White from house to white from
remote marked AC N . Black from house to
Black from remote marked AC L. Connect all
green ground wires to Grounded wire from
House.
Supply
circuit
23
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the wire
connections, the wires should be spread apart
with the grounded conductor and the equipment-
grounding conductor on one side of the outlet
box and ungrounded conductor on the other side
of the outlet box. The splices after being made
should be turned upward and pushed carefully up
into the outlet box.
24
Lift canopy up, aligning its keyhole
slot with the preassembled screw
on mounting bracket and twist
clockwise to lock in place. Install
the screw removed in step 17.
Tighten all screws securely.
25
Attached canopy bottom cap
onto canopy by aligning its
notches with the screws on
mounting bracket and twist
clockwise till tight.
26
L o o s e n 2 a n d r e m o v e 1
preassembled scews from the
plate on motor. Save screw for
later use.
27
28
Attach light pan onto the plate on
motor assembly, aligning its keyhole
slots with the screws on plate and
twist clockwise till lock. Re-install
the screw removed in step 26.
Tighten all screw securely.
Loosen two screws and remove one
screw from light pan. Save screw
for later use.
29
Connect white wire from fan to white
wire from light fixture, then connect
black wire from fan to black wire from
light fixture.
30
Align keyhole slots of the light fixture
with the screws on light pan and twist
clockwise till tight. Install the screw
which removed in step 28. Tighten all
screws securely.
20
Set dip switches on the Remote Transmitter
and Remote Receiver to the same settings.
T h i s m u s t b e d o n e s o t h e u n i t s w i l l
communcate properly. If you have other fans
you can set to control from one transmitter
by setting both receivers the same as the
transmitter. If you have more than one fan
with remote. You can set the dip switches to
different positiosns to have seperate control.
Remote transmitter dip switch
Remote receiver dip switch
21
Install remote receiver into the
mounting bracket.
