855-833-6483 OR EMAIL US AT [email protected]
Fuel Valve
Choke Lever
The two way fuel valve is used to control the flow of fuel
from the gas tank to the carburetor. The valve is located
under the gas tank. Turning the fuel valve to the “ON” posi-
tion before starting the engine allows fuel to flow from the
tank to the carburetor. Turning the fuel valve to the “OFF”
position after shutting off the engine stops the flow of
fuel from the gas tank to the carburetor. Always keep the
fuel valve in the “OFF” position when you are not using the
go-kart.
The choke lever is used for starting the engine when it is
cold or when you live in a cold weather climate. It is located
above the air filter on the back of the engine. The choke
lever increases the amount of fuel in the air/fuel mixture
that is delivered to the engine. See the photo to the right.
“Start” - Choke Fully ON “Run” - Choke Fully OFF
Gas Pedal
The gas pedal, painted green and on the right
side of the floor, controls the speed of the engine.
To increase engine speed, push the pedal down.
To reduce engine speed, release the gas pedal.
The gas pedal is spring loaded and will return to the closed
position (engine idle) when you remove your foot.
9
Operating Controls
Brake Pedal
The brake pedal, painted red and on the left side of the
floor, is used to apply the brake to the rear wheel and will
slow or stop the go-kart. When you push on the brake ped-
al, brake fluid is forced into the brake caliper causing the
caliper to close on the brake disc. The amount of force that
you use when pushing the brake pedal will determine how
much braking power is applied. To release the rear brake,
release the brake pedal.
