9
Rear Panel
1.
INPUTS: One HDMI/MHL video input, two HDMI® video inputs, a DisplayPort (DP)
input with corresponding 3.5mm audio input, and a combination VGA video input
with corresponding 3.5mm audio input. The VGA input supports Component (YPbPr)
and Composite (CVBS) inputs using the included VGA to 3x RCA video cable.
2.
OUTPUTS: HDMI output for connection to a local display and HDBT output for
connecting the included HDBaseT™ receiver. The green LED on the RJ45 jack blinks
when power is applied, while the yellow LED illuminates when a successful
connection with the remote HDBaseT receiver is detected. Both outputs are
simultaneously active.
3.
MIC INPUT: 3-pin terminal block for connecting a microphone or line-level audio
device. Place the switch in the 48V position if a condenser microphone that requires
Phantom Power is connected. Place it in the MIC position when a dynamic
microphone is connected and put it in the LINE position when a line-level audio
device, such as a wireless microphone, is connected. The input supports both
balanced and unbalanced connections.
4.
CONTROL: Press the RES RESET button to reset the output video resolution to
1280x720p. Connect the included IR receiver to the IR IN jack if you want to control
the remote display from the scaler/switch end. Connect the included IR transmitter
to the IR OUT jack if you want to control the source devices from the remote
location. Plug the included IR receiver into the IR EYE jack if the IR "eye" on the front
panel is blocked, such as when the scaler/switch is in a closet or equipment cabinet.
Plug a USB flash drive with a firmware update file into the FIRMWARE port in the
