20
INITIAL SETUP
Perform the following steps for the initial power on and setup.
1.
Ensure that the Power Switch is in the OFF position.
2.
Using a small flat head screwdriver, turn all six GAIN controls on the rear panel
fully counterclockwise to the minimum position.
3.
Using a small flat head screwdriver, set all five BASS and all five TREBLE tone
controls on the front panel to the midpoint 0 position.
4.
Turn all ten LEVEL controls on the front panel fully counterclockwise to the 0
position.
5.
Flip the Power Switch to the ON position. After a few seconds, the POWER/PROT
LED should glow blue, indicating that the amplifier is operating properly. If it
glows red instead, turn the amp off and check all connections.
6.
The LCD Display on the media player should show the time. If not, press the
MODE button repeatedly until the time is displayed.
7.
Press and hold the MODE button until the display starts blinking the year.
8.
Using the
button to increase the displayed value or the
button to
decrease the displayed value, set the displayed year to the current year.
9.
Press the MODE button and the display will change to show the month and
date, with the month flashing. Use the
and
buttons to set the displayed
month to the current month.
10.
Press the MODE button and the date will start to flash. Use the
and
buttons to set the displayed date to the current date.
11.
Press the MODE button to display the time, with the hour value blinking. Use the
and
buttons to set the displayed hour to the current hour. Note that it
uses a 24 hour clock.
12.
Press the MODE button and the minute value will start blinking. Use the
and
buttons to set the displayed minute to the current minute.
13.
Press the MODE button to save the newly set date and time values.
14.
Press the MODE button until an FM frequency number is displayed.
15.
Use the
and
buttons to tune to a local FM station.
Содержание 18802
Страница 18: ...18 Sample Connection Diagram ...
Страница 19: ...19 Block Diagram ...