Installation
42" Built-In Refrigerator
Before you begin – Read these instructions completely and carefully.
IMPORTANT – Save these instructions for local inspector’s use.
IMPORTANT – OBSERVE ALL GOVERNING CODES AND ORDINANCES.
Note to Installer – Be sure to leave these instructions with the Consumer.
Note to Consumer – Keep these instructions with your Use and Care Book for future reference.
Step 1
Remove
packaging
CAUTION: Refrigerator is much heavier at the top than
at the bottom–be careful when moving.
• Remove outer carton.
–Carefully cut banding at top and bottom.
–Remove top cap.
–Slide out back corner posts (2).
–Slide carton off top of cabinet.
• Remove toekick from back of refrigerator and set
aside for later installation.
• Remove grille panel frame from front of door, set
aside for later installation.
NOTE: IT IS NOT NECESSARY TO LAY CABINET DOWN
IN ORDER TO REMOVE SKID!
• To remove skid, remove the four 7/16" bolts and their
brackets.
CAUTION: DO NOT ATTEMPT TO ROLL UNIT OFF SKID.
• There are support blocks on the bottom of cabinet
and door. They must be removed before rolling unit off
skid or damage will occur.
• Carefully tilt cabinet and slide blocks out from
underneath cabinet, slide unit off skid.
When using a hand-truck, handle from side only.
7/16" Bolts
Step 2
Prepare
water
line
Floor
Copper Tubing
• Route 1/4" OD copper tubing between house
cold water line and the water connection location.
• Copper tubing should be long enough to
extend to the front of the refrigerator. Allow
enough to accomodate bend leading into the
water valve.
• Install a shut-off valve between the icemaker
water valve and cold water pipe in the base-
ment or a cabinet. The shut-off valve should be
located where it will be easily accessible.
IMPORTANT–(Please read carefully)
FOR PERSONAL SAFETY, THIS APPLIANCE MUST
BE PROPERLY GROUNDED.
The power cord of this appliance is equipped with a
three-prong (grounding) plug which mates with a
standard three-prong grounding wall receptacle to
minimize the possibility of electric shock hazard from
this appliance.
If the electrical service provided does not meet the
above specifications, it is recommended that a
licensed electrician install an approved outlet.
Step 3
Grounding the
appliance
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR
REMOVE THE THIRD (GROUND) PRONG FROM THE
POWER CORD.
DO NOT USE AN EXTENSION CORD WITH THIS
APPLIANCE.
DO NOT USE AN ADAPTOR PLUG WITH THIS
APPLIANCE.
Caution:
Refrigerators are
much heavier at the top than at
the bottom–be extra careful
when moving.
15
PRODUCT
INSTALLATION
