19
31-49133-1
FRONT VIEW
SIDE VIEW
W
24"
(61.0)
3/4"
(1.91)
E
WATER
47 1/2"
(120.7)
20"
(50.8)
*83 1/2" min
*84 1/2" max
(212.1-214.6)
*Trim will overlap
additional 7/16 "
3 1/2"
(8.9)
75"
(190.5 )
From floor
to bottom
of electrical
area
6"
(15.2)
5"
(12.7)
5"
(12.7)
5"
(12.7)
FRONT VIEW
SIDE VIEW
W
24"
(61.0)
3/4"
(1.91)
E
WATER
41 1/2"
(105.4)
18"
(45.7)
*83 1/2" min
*84 1/2" max
(212.1-214.6)
*Trim will overlap
additional 7/16 "
3 1/2"
(8.9)
75"
(190.5 )
From floor
to bottom
of electrical
area
6"
(15.2)
5"
(12.7)
5"
(12.7)
5"
(12.7)
DUAL RETRO-FIT INSTALLATION SPACE
Dimensions in parentheses are in centimeters.
Design Guide - Dual Retro-Fit Installation
Water And Electrical Locations
Electrical and water supply must be located as shown.
For 24” Deep Cutouts
Trim Retro kits are required for a 41.5”(ZTKC42) or a
47.5” (ZTKC48) wide opening.
Heater Unification Kit ZUGC required
Product Clearances
These units are equipped with a 2-position door stop.
The factory set 115° door swing can be adjusted to 90°
if clearance to adjacent cabinets or walls is restricted.
For a 90° door swing, allow 4” (10.2 cm) minimum
clearance to a wall.
When installed in a corner, allow 15” (38.1 cm) for a full
115° door swing on 18” and 24” models. Allow 16.5”
(41.9 cm) on 30” models.
Additional Specifications
• A separate 115 volt 60Hz., 15 or 20 amp power supply
is recommended for each product. An individual
properly grounded branch circuit or circuit breaker is
recommended. Install a properly grounded 3-prong
electrical receptacle recessed into the back wall.
Electrical must be located on rear wall as shown.
• Water line must be located on the back wall as shown.
The water line should be 1/4” O.D. copper tubing or
QuickConnect
™
kit (WX08X10006) between the cold
water line and water connection location, long enough
to extend to the front of the unit (8’ [2.4m]). Installation
of an easily accessible shut-off valve in the water line
is required.
