Monogram ZIR240NPKII, Руководство по установке

Страница: 47 / 116

47
31-49133-1
Installation Instructions - Stainless Door Panel
STEP 1 REVERSE STAINLESS
PANEL DOOR SWING (if necessary)
(Cont.)
Ŷ
Move the bottom panel
band toward the bottom
of the door to the empty
2 holes on each side
and tighten with the
2 previously removed
screws.
Ŷ
Install the bottom
mounting bracket at the
bottom of the door panel
into the bottom group
of 3 holes on each
side. Use the 6 T20
Trox screws previously
removed.
Ŷ
Remove the 6 T20 Trox screws holding the top
mounting bracket.
Ŷ
Remove the 2 T20 Torx screws holding the top panel
band.
Ŷ
Slide the return flange at the top of the door into the
hook on the panel cover and push into place. Align
the 2 cover screw holes and drive 2 T20 Torx screws
to secure the panel cover.
STEP 1 REVERSE STAINLESS
PANEL DOOR SWING (if necessary)
(Cont.)
Ŷ0RYHWKHWRS
panel band
down the
door to the
next set of 2
empty holes on
each side and
tighten with the
2 previously
removed
screws.
Ŷ0RYHWKHWRSPRXQWLQJEUDFNHWGRZQWKHGRRUSDQHO
to the next set of 3 holes on both sides and install
with the 6 T20 Torx screws previously removed.
Ŷ
The previous top of the door panel is now the bottom
of the door panel.
Bottom Panel
Band
Bottom
Mounting
Bracket
Top Mounting
Bracket
Top Panel
Band
Top Mounting
Bracket
Top Panel
Band
Return
Flange
Hook
Panel Cover
STEP 2 INSTALL STAINLESS PANEL
Ŷ
Remove bottom hinge cover and retain the 4 T30
Torx screws for later installation.
Ŷ
Open door to 90°. Slide the
panel onto the door with the
panel brackets interlocking
on top and bottom with the
door brackets (make sure
not to slide the panel into
the cabinetry surround).
Center the panel on the
door, then slowly close
the door while watching to
make sure the panel does
not contact the surrounding
cabinetry.
Ŷ
With the door fully closed,
carefully slide the panel towards
the cabinetry with the goal gap
of 1/8”.
Bottom
hinge
cover
T30 Torx
screws
Door
Bracket
Panel
Bracket
Panel
1/8” gap
Cabintery
Surround
Overlay
Panel