Monogram ZIR240NPKII, Руководство по установке

Страница: 24 / 116

24
31-49133-1
Installation Instructions - Dual Retro-Fit Installation
STEP 4 INSTALL ANTI-TIP BRACKET
(Cont.)
STEEL MOUNTING: Predrill with a 1/2” drill bit, insert
toggle, then install bolts with a 7/16” driver.
The bracket must be screwed to either the FLOOR or
REAR WALL.
Ŷ
Tape the waterline to the floor approximately 3” to the
left of the anti-tip bracket. Apply tape about every 5”
toward the front of the opening (tape will prevent the
unit from rolling over the waterline during installation).
Do not tape near the cabinet front in order to keep
tape hidden under the unit.
Ŷ
Route the strapping coiled up at the back of the unit
through the anti tip bracket.
1. Cut the wire tie holding the strap bundle.
2. Put the strap on the backside of the retaining pin.
3. Secure the retaining pin to the bracket with the
cotter pin.
4. Repeat strap routing on the second unit.
Retaining
Pin
Cotter
Pin
STEP 5 JOINING DUAL INSTALLED
UNITS
Ŷ
Place the left hand unit in front of the opening.
Ŷ
Install top unification bracket between the 2 units by
sliding in place over the two shoulder bolts.
Ŷ
Install the bottom unification bracket using a 3/8”
driver (4 screws).
3"
5"
3"
5"