V. SETTING UP YOUR WATER DETECTION PUCK
INSTALLING BATTERIES
When you are finished adding the Water Detection Puck to your account, the next step is
to insert the battery. ALTA Water Detection Puck Sensors will be powered by commecial
AA batteries.
The standard version of this sensor is powered by two
replaceable 1.5 V AA sized batteries (included with
purchase). The typical battery life is 10 -12 years.
This sensor is also available with a line power option. The
line powered version of this sensor has a barrel power
connector allowing it to be powered by a standard 3.0–3.6
V power supply. The line powered version also uses two
standard 1.5 V AA batteries as backup for uninterrupted
operation in the event of line power outage.
Power options must be selected at time of purchase, as
the internal hardware of the sensor must be changed to
support the selected power requirements.
Place batteries in the device by first taking the sensor and
sliding the battery door open. Insert fresh AA batteries in
the carriage, then shut the battery door.
Complete the process by opening up iMonnit and selecting
Sensors
from the main navigation menu. Verify that
iMonnit is showing the sensor has a full battery level.
PAGE 5
The Water Detection Puck comes equipped with rubber pads on the bottom. There is no
mounting necessary for the device. Just place it in the designated space and it’s ready to
go.
