Type 318.xx
2018-12-17
26
Improper assembly and initial startup
CAUTION
Danger of burns due to improper
handling of the heated hubs!
►
Wear gloves when handling hot hubs.
WARNING
Danger of explosion when heating a hub
for press-fitting assembly in potentially
explosive areas!
►
Heating the clutch in potentially explosive
areas may only take place after
considering the maximum permitted
temperatures for the location.
►
The assembly area must be approved
before assembly as "no explosion risk
area".
6.2.2.
Assembling the clutch
Check the parts for completeness, dimensional stability and damage. Check the bore of the
flanged hubs for burrs and eliminate them if necessary.
Clean and degrease shaft ends and bores thoroughly.
NOTE
The shaft fitting should be h7 to j6
The bore fitting is H7 as standard.
