Moni JJ2168, Инструкция по эксплуатации

Страница: 23 / 25

22
BATTERY CHARGE STATE OF THE BATTERY
12V10Ahx1, 12V7Ah*2
≥13.2
The battery is full.
13.1~12.6 The battery operated jeep can work normally.
≤12.5
STOP using the battery operated jeep, because the
battery must be charged.
SEE FIGURE 18:
1.Plug the bushing of the adapter in the charging socket. (The charging socket is under the seat.)
2.Insert the plug of the adapter in a socket of the main electric grid. The battery will start charging.
WARNING!
This product is with option for PROTECTION WHILE CHARGING : When you charge the battery operated jeep,
all functions will turn off!
REMOVAL OF THE DISCHARGED BATTERY
REPLACING OF THE BATTERY AND FUSE
The battery operated jeep is equipped with self-restoring fuse (thermal fuse) in case the motor, electric system or battery get
overloaded it stops the power. The thermal fuse will restore the power after the battery operated jeep turns off for 5 minutes
and afterwards it will turn back on. If the thermal fuse keeps disconnecting during normal use, the battery operated jeep may
need being repaired.
Contact the shop you bought the product from or the importer.
In order to avoid loss of energy, follow these guidelines:
• Do not overload the battery operated jeep.
• Do not tie anything to the rear part of the jeep.
• Do not use the battery operated jeep on steep hills.
• Do not drive the jeep against immovable objects, because this may lead to turning of the wheels and overheating of the
motor.
• Do not use the battery operated jeep in very hot weather, because its components may get overheated.
• Do not allow water or other liquids to get in contact with the battery or other electric components.
• Do not repair or change anything on the electric current of the battery operated jeep. Otherwise there may be short circuit
and the fuse may disconnect.
Your battery at one point will lose its ability to hold charge. Depending on the amount of use and varying conditions, the
battery should be used between one and three years. In order to replace the battery and remove the discharged one, follow
the steps below:
1. Remove the seat of the battery operated jeep.
2. Remove the jacks of the
battery’s cables.
3. Remove the metal bracket that protects the battery from falling.
4. Remove the lid of the battery compartment.
5. Carefully lift the battery.
• Depending on the state of the battery (for example leakage) you may have to wear protective gloves before you
remove the battery.
• Do not lift the battery by its terminals or cables.
6. Place the discharged battery in a plastic packaging.
Important! The sealed lead-acid battery must be recycled or thrown away in an ecologically friendly manner for the purpose
of avoiding pollution of the environment. The battery contains lead acid (electrolyte) and must be discarded in an ecologically
friendly manner in accordance with the regulatory requirements. DO NOT throw the rechargeable battery in fire, because it
may explode or leak. DO NOT throw the lead-acid battery in the containers for household waste. The incineration (burning),
land filling or mixing of the sealed lead-acid batteries with the household waste is forbidden by law. The discharged
rechargeable battery can be given at the local recycling center for recycling or at a center for sale of such batteries.
7. Replace the battery with new one and reconnect all cables and terminals.
8. Place the metal bracket protecting the battery from upturning or falling back on.
9. Return the seat of the battery operated jeep back in place.