background image

3

3-90-733069

Monessen • Sundance VF Installation Manual_R1 • 04/17

CARBON MONOXIDE POISONING 

MAY LEAD TO DEATH!

Carbon Monoxide Poisoning:

  Early  signs  of  carbon 

monoxide poisoning resemble the flu, with headaches, 

dizziness, or nausea. If you have these signs, the heater 

may not be working properly. Get fresh air at once! Have 

the heater serviced. Some people are more affected by 

carbon  monoxide  than  others. These  include  pregnant 

women, people with heart or lung disease or anemia, those 

under the influence of alcohol, and those at high altitudes.

8.  DO NOT obstruct the top grille at all. Doing so will cause 

high levels of carbon monoxide that will lead to death.

9.  This heater needs fresh, outside air ventilation to operate 

properly. Refer to Fresh Air Requirements.

10. This  heater  shall  not  be  installed  in  a  room  or  space 

unless the required volume of indoor combustion air is 

provided by the method described in the National Fuel 

Gas Code, ANSI Z223.1/NFPA 54, the International Fuel 

Gas Code or applicable local codes.

11.  If heater shuts off, heater may not have enough fresh 

air ventilation. Provide more fresh air. If heater keeps 

shutting off, refer to Troubleshooting.

12. DO NOT operate this heater 

•  where flammable liquids or vapors are used or stored
•  under dusty conditions.

13. The  heater  becomes  very  hot  when  operating. Alert 

children and adults to stay away from hot surfaces to 

avoid burns or clothing ignition. The heater will remain 

hot for a time after shutdown. Allow surface to cool before 

touching.

14. Carefully supervise young children when they are in the 

room with the heater.

15. Do  not  use  the  heater  if  any  part  has  been  exposed 

to or under water. Immediately call a qualified service 

technician to inspect the room heater and to replace any 

part of the control system and any gas control which has 

been under water.

16. DO  NOT  operate  the  heater  if  any  log  is  broken  or 

damaged.

17. Turn  heater  off  and  let  cool  before  servicing.  Only  a 

qualified service person should service and repair heater.

18. DO NOT operate this appliance with the safety screen 

removed.  If  the  safety  screen  is  removed  from  the 

appliance for service or cleaning, it must be replaced 

before operating the heater.

NOTE:  If  any  of  the  original  wire  as  supplied  with  the 

appliance must be replaced, it must be replaced with a wire 

of at least 105°F temperature rating.

A. Important Safety Information

In order to ensure safe and effective installation, this unit 

must be installed only by a qualified agency, individual, firm, 

corporation or company that is experienced in the installation, 

repair and servicing of this type of appliance and is familiar 

with the building codes and installation techniques appropriate 

in your area. Contact your hearth products dealer or local gas 

supplier for the name of a qualified service person.
In the Commonwealth of Massachusetts, all gas fittings and 

installation of this heater shall only be done by a licensed 

gas fitter or licensed plumber.

IMPORTANT: 

Read  this  owner’s  manual  carefully  and 

completely  before  trying  to  assemble,  operate,  or  service 

this heater. Improper use of this heater can cause serious 

injury or death from burns, fire, explosion, electrical shock, 

and carbon monoxide poisoning. Failure to follow instructions 

may result in property damage, bodily injury or loss of life. 

This manual contains important user information. Keep this 

manual with the heater after installation is complete.

FOR SAFE INSTALLATION AND OPERATION, PLEASE 

NOTE THE FOLLOWING:

1.  Use only Natural Gas with model 4050. Use only Propane 

with model 4051. Do not use any other fuels.

2.  Install  only  in  accordance  with  the  National  Fuel  Gas 

Code, ANSIZ223.1/NFPA54-latest edition. (Exception: Do 

not derate this appliance for altitude. This appliance has 

been tested and listed for use in altitudes up to 10,000 

feet.)

3.  Use  only  the  installation  instructions  provided  by  the 

manufacturer  for  this  appliance.  Installation  and  repair 

should  be  done  by  a  qualified  installer,  preferably  NFI 

or  WETT  (Canada)  certified.  The  appliance  should 

be  inspected  before  use  and  at  least  annually  by  a 

professional service person. More frequent cleaning may 

be required due to excessive lint from carpeting, bedding 

material, etc. It is imperative that control compartments, 

burners and circulating air passageways of the appliance 

be kept clean.

4.  WARNING: Any change to this heater or its controls can 

be dangerous. DO NOT make modifications to any heater 

or associated parts.

5.  DO NOT install this heater in a bedroom or bathroom.
6.  Due to high surface temperatures, DO NOT install this 

heater

•  in a recreational vehicle, 
•  where curtains, furniture, clothing or other flammable 

objects are less than 36 inches from the front, top or 

sides of the heater,

•  in high traffic areas,
•  in windy or drafty areas.

7.  DO NOT place clothing or other flammable material on or 

near the appliance.

Safety & Operations 

Содержание SD30NV























Отзывы: