Monark Ergomedi 894 E, Руководство пользователя

Страница: 9 / 19

2
3
4
1
5
6
7
8
9
10
Monark 894 E
10
Adjusting the brake cord/belt tension
1. Check at first that the brake belt is lying correct
on the flywheel brake surface. See
Fig: Brake cord
and Brake device. If the weight basket is in its upper
position, press the release button(1). The basket will
fall down and increase the tension of the brake belt/
cord against the flywheel. Put 9 kg in the weight
basket(6). See
Fig: Brake device. Rotate the flywheel
by hand. The basket shall now lift up so the distance
to the flywheel is at least 40 mm /1.6" and maximum
60 mm / 2.4". If this is not the case the brake belt has
to be loosened or tightened at the tension centre (4).
If the basket is too low, shorten the belt somewhat. If
the basket is too high, lengthen the cord somewhat.
Tighten the bracket again and check that the distance
between the weight basket and flywheel is between 40
and 60 mm when the flywheel is rotated by hand.
2. Also check the brake cord tension with no load
weight basket. Then check the distance between the
pin on the tension center and the tip of the magnet
arm, as shown in Fig:
Brake device This distance
should be between 5 and 10 mm (1/4" and 1/2").
NOTE!
To receive correct workload it is important to place the
weight basket according to the description above.
Fig: Brake cord
Fig: Brake device
1) Release button
2) Stop
3) Cord bracket
4) Tension center
5) Return strap
6) Weight basket
7) DC connector
8) PC serial port
9) Pin on tension center
10) Tip of the magnet arm
5-10 mm