Molift QUICK RAISER, Руководство по эксплуатации

Страница: 14 / 20

Page 14 of 0
E Rev. G/ 09/006
• On QR2+ the ropes is attached to the lifting arm
bt pulling them firmly from above into the rope
locks as shown on the illustration.
The ropes must be tightened firmly to avoid
them sling to much when lifting the patient.
The rope will lock itself due to the weight of
the patient, but if sliding too much before
locking, it may cause an uneven lift and dis-
comfort for the patient.
• Raise the patient carefully until the buttocks are
clear from the seating. Unlock the wheels on the
lifter and move the patient to the next location.
Movement
The patient should not be standing straight
up during movement - this can be experi-
enced as uncomfortable.
Be careful during movement not to run into furni-
ture, walls, doors etc.
The lifter shall not be used to lift or move us-
ers on sloping surfaces.
Avoid deep pile carpets, high thresholds, uneven
surfaces or other obstacles that may block the cas-
tors. The lifter may become unstable if forced over
such obstacles increasing the risk of tipping over.
The lifter shall only be used for movement
over short distances. It is not a replacement
for wheelchair or similar.
Lowering
• Lower the patient into sitting position at the de-
sired place
If the patient is to be seated into a wheelchair,
please observe that the wheel brakes must be
locked on the wheelchair when lowering, but
NOT on the lifter.
• Release ropes from locks and remove the sling