Hand Crimp Tool for Milli-Grid™ Crimp Terminal
Doc No: ATS-011010204
Release Date: 03-02-93
UNCONTROLLED COPY
Page 4 of 5
Revision: E
Revision Date: 04-14-08
Notes:
1.
This tool should only be used for the terminals and wire gauges specified on this sheet.
2.
This tool is not adjustable for crimp height; however crimp force is adjustable (See instructions above).
Variations in tools, terminals, and wire stranding and insulation types may affect crimp height.
3.
This tool is intended for standard conductor sizes. It may not give a good insulation crimp support for all
insulation sizes.
4.
Molex does not repair hand tools (see warranty above). The replacement parts listed are the only parts
available for repair. If the handles or crimp tooling is damaged or worn, a new tool must be purchased.
5.
Pull force should be used as the final criteria for an acceptable crimp. Pull force is measured with no
influence from the insulation crimp. The insulation should be stripped long (1/2 in.) so the insulation grips on
the terminal do not grip the wire insulation or the conductor. Refer to Molex Quality Crimping Handbook
63800-0029 for additional information on crimping and crimp testing.
6.
Molex does not certify crimp hand tools.
CAUTION
: Molex crimp specifications are valid only when used with Molex terminals, applicators and
tooling.
