Hand Crimp Tool For C-Grid III™ Female Crimp Terminals
Doc No: ATS-638258100
Release Date: 11-27-12
UNCONTROLLED COPY
Page 4 of 7
Revision: B
Revision Date: 11-1-16
Figure 8
PUSH ON
HANDLE
JAWS OPEN
PULL OPEN
TOOLING
TOOLING
M3 BHCS
MATCH
UP MARKS
FRONT
BACK
Figure 9
1.
Open the crimp hand tool.
2.
Squeeze gently on the lower area shown
in Figure 7A with your thumb and index
finger. The lower tabs of the locator
should disengage from the hand tool.
3.
Lift and pull away from the hand tool. The
top locator hooks should slip out of the top
slots easily. See Figure 7A.
4.
To reinstall the new locator, make sure the
hand tool is in the open position.
5.
Press the red insert down as far as it will
go as shown in Figure 7B.
6.
Holding onto the lower part of the locator
with your thumb and index finger, insert
the locators top hooks (2) into the hand
tool top slots.
7.
Rotate the locator down and press the
lower tabs into the two bottom slots of the
hand tool. To secure the locator into
place, the lower tabs must snap into place on the
hand tool frame.
Right or Left Hand Operation
This hand tool has an added feature that can be
converted from a right handed application to a left
handed application. It is necessary to reverse the
tooling if using the left handed application along with
the locator. Follow the steps below:
1.
The locator must be removed before reversing
the tooling.
2.
Remove the M3 BHCS which is holding the upper
tooling.
3.
Flip the upper tooling to the opposite side and replace the M3 BHCS. Make sure the small markings on the
front and back of the hand tool frame, match up and are on the outside of the hand tool frame. See Figure 8
and 9.
4.
Do the same thing with the lower tooling and tighten
the M3 screws. Be sure the small markings line up.
5.
Reinstall the locator by following the Instructions in
the locator replacement section.
MAKE SURE
CENTER OF LOCATOR
IS IN THE
DOWN POSITION
Figure 7B
SQUEEZE
HERE
SQUEEZE
HERE
LOCATOR
Figure 7A
TOP HOOKS
TOP SLOTS OF
HANDTOOL
LOWER TABS
