Tool Kit for 2.80mm (.110") Sealed Crimp Terminal, Male and Female
Doc No: ATS-6382519HM Release Date: 01-24-12
UNCONTROLLED COPY
Page 3 of 8
Revision: A
Revision Date: 01-24-12
SWING
LOCATOR
OPEN
PRESS DOWN
ON THE BRASS
PIVOT SHAFT
LIFT UP ON
THE LOCATOR
Figure 2
Locator Installation and Removal
Follow the steps below to install or replace the locator. See Figure 2.
To install the locator
1.
Position the locator with the hole over the brass pivot shaft and snap it
into place.
To remove the locator
1.
Open the crimp hand tool.
2.
Swing the existing locator open and away from the hand tool.
3.
Firmly press down on the brass pivot shaft with your thumb, while
pulling the locator up. Slip the locator off the top of the brass pivot
shaft.
OPERATION
Open the tool by squeezing the handles together, at the end of the closing stroke, the ratchet mechanism will
release the handles, and the hand tool will spring open.
Crimping Terminals
1.
Select the desired terminal listed in the preceding
charts.
2.
Turn the Locator Lock Latch down to unlock. See
Figure 3.
3.
Swing the terminal locator away from the crimp tool
shown in Figure 4. Some terminals with large
insulation grips may interfere with the crimp tooling
when swinging the locator into position. The terminal
must then be loaded into the locator in the closed
crimp position. See Figure 5.
4.
Press down on the wire stop on the locator as shown in Figure 4.
5.
Insert the proper terminal into
the proper nest opening.
Make sure when choosing
the nest opening, it will
correspond with the A, B, or
C profile on the hand tool.
6.
Return the locator to its
original position.
SWING OPEN
TERMINAL
PUSH HERE TO
OPEN WIRE STOP
LOCATOR
LOCATOR
TERMINAL IN PLACE
Figure 4
Figure 3
LATCH LOCKED
LATCH UNLOCKED
