Tool Kit for 1.80mm (.070”) Wide VersaBlade™ Crimp Terminals
Doc No: ATS-6381906HM Release Date: 08-29-07
UNCONTROLLED COPY
Page 3 of 9
Revision: D
Revision Date: 09-17-10
ANVILS
POWER
CRIMP
HEAD
Figure 1
PUNCHES
M4 X 10 LONG
BHCS
M4 X 18 LONG
BHCS
SWING
LOCATOR
OPEN
PRESS DOWN
ON THE BRASS
PIVOT SHAFT
LIFT UP ON
THE LOCATOR
Figure 2
SWING OPEN
TERMINAL
PUSH HERE TO
OPEN WIRE STOP
LOCATOR
LOCATOR
TERMINAL
IN PLACE
Figure 3
LOCATOR LATCH
IN OPEN POSITION
INSTALLATION
To install the Tool Kit into the Power Crimp Head follow the steps below:
Anvils and Punches Installation
1.
Insert the Anvils into the bottom slots of the nest. Install the M4 x 10 long BHCS and tighten in place.
2.
Insert the Punches into the top slots of the nest. Install the M4 x 18 long BHCS and tighten in place. See
Figure 1.
Locator Installation and Removal
Follow the steps below to install or replace the locator. See Figure 2.
To install the locator
1.
Position the locator with the hole over the brass pivot shaft and snap it into place.
To remove the locator
1.
Open the crimp hand
tool.
2.
Swing the existing
locator open and away
from the hand tool.
3.
Firmly press down on
the brass pivot shaft
with your thumb, while
pulling the locator up.
Slip the locator off the
top of the brass pivot
shaft.
