MoJack HDL 45501, Инструкция по сборке и эксплуатации

Страница: 5 / 17

8 9
MoJack HDL Mower Lift | | MoJack HDL Mower Lift
ASSEMBLY AND OPERATING INSTRUCTIONS
STEP 6
Raising the mower.
Insert the handle into the cylinder handle opening.
Proceed to pump the handle up and down to raise the lift to
the desired height. The cylinder will use pumping action of
the handle to raise the lift.
The automatic locking mechanism will engage at three
different lift heights.
The 3 locking positions are: 18” , 21”, 24”
NOTE: Make sure your mower is in neutral before you raise
your mower. The mower wheels need to move freely as the
mower raises.
STEP 5
Secure the front mower tires to the Wheel
Pads using the Safety Straps.
Extend the Safety Strap over the top of tire or
over the top of mower wheel arm and secure the
hook into the loop on the wheel pad.
Squeeze the metal buckle and pull end of strap
to tighten the Safety Straps over the top of the
tires to secure mower to Wheel Pads.
NOTE: Inspect Safety Strap for wear before
each use.
ASSEMBLY AND OPERATING INSTRUCTIONS
Preparing the mower for service.
Place wheel chocks (not included) behind the back tires of the mower
and apply the parking brake on the mower.
YOU MAY NOW SERVICE THE MOWER. Wheel Chock
STEP 7
The automatic locking mechanism
must be engaged in one of the three lock
position notches on the Locking Bar
before proceeding to service mower.
STEP 8
Lowering the mower.
Use the handle to turn the release valve on the
Hydraulic Cylinder. The grooves in the bottom of
the handle will interlock with the release valve.
To lower the mower, slowly open the release valve
by turning the handle counterclockwise, while at
the same time releasing the Locking Bar.
NOTE: It may be necessary to first slightly raise
the mower in order to release the Locking Bar.
Safety Strap
Wheel Pad