Mohawk FL-25, Руководство пользователя, Страница: 16 / 58

MOHAWK MODEL TR-25A, FL-25, TR-19
16
PRE - OPERATION CHECK LIST
TRAINED OPERATOR
x
THE OPERATOR MUST BE FULLY TRAINED AND QUALIFIED TO
SAFELY AND EFFECTIVELY OPERATE THIS EQUIPMENT OF
THIS SPECIFIC MAKE AND MODEL.
ABSENCE OF OBSTRUCTIONS
x
THE TOTAL WORK AREA MUST BE FREE OF ANY AND ALL
OBSTRUCTIONS AND BE GENERALLY CLEAN. ( FREE OF OIL
AND DEBRIS )
VISUAL INSPECTION
x
THOROUGHLY INSPECT THE UNIT WITH A TRAINED EYE,
NOTING ANY PROBLEM AREAS. INSPECT THE FLOOR AND
THE ANCHORING FASTENERS AS WELL. REPORT ANY
QUESTIONABLE ITEMS.
NO LOAD PERFORMANCE CHECK
x
ALL MECHANICAL SAFETIES OPERATE PROPERLY AND
CONSISTENTLY.
x
NO EXTERNAL FLUID LEAKS.
x
NO BLEED DOWN.
x
EFFORTLESS AND SIMULTANEOUS MOVEMENT.
x
LEVEL LIFTING.
x
CONTROLS FUNCTION PROPERLY.
x
ALL SAFETY MECHANISMS FULLY FUNCTIONAL.
PREVIOUS DAY' S OPERATION REPORT
x
VERIFY WITH SUPERVISOR THAT THERE WERE NO PROBLEMS
EXPERIENCED THE PREVIOUS DAY. IF THERE WERE ANY
PROBLEMS, VERIFY THAT ALL NECESSARY
REPAIRS
HAVE
BEEN COMPLETED.
LIFTING PROCEDURES
OPERATION
PERFORM PRE-OPERATION CHECK LIST ITEM BY ITEM.
ENSURE UNIT IS COMPLETELY LOWERED.
POSITION THE VEHICLE ONTO THE UNIT.
CAUTION
x
AVOID SUDDEN STARTS AND STOPS DURING LOADING AND
UNLOADING OF VEHICLE.
POSITION THE VEHICLE AS INDICATED BY THE MFG’S
RECOMMENDED LIFT POINTS.
NOTE
x
ALIGN THE CENTER OF GRAVITY ( C.G. ) OF THE VEHICLE
WITH THE CENTERLINE OF THE TRACKS.
POSITION THE WHEEL CHOCKS AS INDICATED BY THE MFG’S
RECOMMENDED LIFTING INSTRUCTIONS.
TO RAISE
x
ENGAGE THE UP-BUTTON ON THE POWER UNIT.
x
RAISE VEHICLE TO THE DESIRED WORKING HEIGHT.
x
LOWER THE UNIT ONTO THE MECHANICAL SAFETIES.
TO LOWER
x
INSPECT THE LIFTING AREA TO INSURE THAT ALL
PERSONNEL AND DEBRIS HAVE BEEN CLEARED FROM THE
LIFTING AREA.
x
ENGAGE THE UP-BUTTON ON THE POWER UNIT.
x
RAISE UNIT APPROXIMATELY THREE TO FOUR INCHES.
x
DISENGAGE THE MECHANICAL SAFETIES.
x
LOWER UNIT TO THE DESIRED WORKING HEIGHT.
x
ALWAYS ENGAGE THE UP-BUTTON ON THE POWER UNIT AND
RAISE UNIT UNTIL BOTH MECHANICAL SAFETIES RE-ENGAGE.
x
LOWER THE UNIT ONTO THE MECHANICAL SAFETIES.
x
IF WORK IS COMPLETE, CONTINUE LOWERING THE
UNIT TO FLOOR.