These instructions are produced as a guide only.
• Decide the position that the unit is to be fixed to the wall.
• Measure and mark out the location for the fixing holes on the wall.
Check the area for hidden pipes and wires with a detector.
• Mark out fixing positions on the wall
• Drill the holes for your screws. Remember to use the necessary safety equipment and to
also use the correct drill and bit for the surface type.
Make sure that the screws and wall plugs being used are suitable
for supporting the unit.
• Tap in a wall plugs, then offer up the unit in place.
• Check the unit is level with a spirit level.
• Fit the unit to the wall and screw in place.
Do not place any barriers within the hand sensor range
Models: SDCU, and SDRU can also be fixed to a rear wall.
1: Wall Mounting ( Model SDHU.)
5