5
INS10634C - 11/18
Drill a mounting hole with a diameter of 8mm and a depth of 45mm at the
drawn outline, and drive into the plastic expansion tube.
在画出的轮廓处钻直径
8
mm，深
45
mm的安装孔，并打入塑料膨胀管。
在孔内打入塑料膨胀管后，用自攻螺钉将底座上紧并固定在墙上。
注意：
•
请按图将螺丝孔位错位摆放。
将电源线通过底座圆孔穿入PVC穿线管并到达预埋开关盒，后使用紧定螺
钉将产品安装在底座上，并上紧。
Pass the power cord through the round hole of he base into the PVC
conduit and reach the embedded switch box, then use the set screw to
install the product on the base and tighten it.
Drive a plastic expansion tube into the hole, tighten the base with
self-tapping screws and fix it on the wall.
Note:
•
Please place the screw holes in a misplaced position according to the
picture.
5
7
45mm
紧定螺钉
电源线通到
开关面板处
Undercounter Installation
Refer to the installation instructions of the panel switch to connect the
power cord and tighten the panel switch to the switch box.
After the installation, check if the product is installed firmly and the
power cord is correctly connected before product power on.
参考面板开关的安装说明将电源线进行连接，将面板开关上紧在开关盒上。
安装完成，确认产品已经安装牢固，电源线正确连接后，方可通电使用产
品。
8
控制面板
Control Panel
Set Screw
The power cord
goes to the
switch panel
Undercounter Installation
Ø
8mm
6
塑料膨胀管
自攻螺钉
Self-tapping Screw
Plastic Expansion Tube
