Modena PX 6001, Руководство пользователя

Страница: 19 / 26

-
Make holes on the two previous signs using a drill bit with the diameter of 8 mm or the size of the nut.
Then insert the nut into the holes.
Caution:
-
Before drilling, make sure that there is no cable, water pipe and other installations on the walls.
-
Put the screw on the two top holes and let a distance of 1 cm between the screw head and the wall
surface.
-
Attach the cooker hood on the wall that has been fastened by screws by hanging the cooker hood on the
screws.
-
If the position of the cooker hood on the wall is correct, tighten the two screws.
-
Then close the grid.
-
Install the safety ventilation using screws 6 mm in diameter.
-
Connect the waste pipe with Spigot/ Flange if the cooker hood will be used as ducting/ exhaust system.
Installing on the bottom of the kitchen set cabinet
-
Place the sucker cap on the bottom of the kitchen
set cabinet in accordance with the planned
position precisely.
-
Make signs at the bottom of the kitchen set
cabinet for flexible pipe holes and then make the
holes if the cooker hood will use the ducting/
exhaust system.
-
Drill 4 holes with diameter of 6 mm at the
appropriate position. Attach the spigot/ flange and
then attach the cooker hood and fasten with 4
screws at the position that has been prepared.
-
Attach the controller board on the bottom of the
cooker hood to prevent the gap between the
cooker hood and the kitchen set.
Note:
4. Pipe extension is an additional accessory, not included in the unit.
5. Remove the protective layer before mounting.
6. There are 2 methods of ventilation, that is: 'horizontal ventilation' and 'vertical ventilation'.
Please note when doing installation.
Open the cover of the outlet at its top to apply vertical
ventilation system. See Fig. A. Meanwhile, applying the
horizontal ventilation system can be done by removing the
cover on the outgoing airways on the back of the unit. See
Fig.B.
Rectangular outlet for horizontal ventilation is not included.
English 16