Modena Forte Series, Руководство пользователя

Страница: 9 / 19

9
In this version, the exhaust hood sucks the smoke / cooking odor and
filters it through an aluminum filter and carbon filter. The filtered smoke
is then re-circulated into the room. This system is used if the premise
renders it impossible to install a ducting system.
Several things which must be ensured when installing a exhaust hood
with recirculation system:
1.
Both carbon filter and aluminum filter must be used.
2.
The position of both filters must be correct.
3.
Holes where air duct is discharged found in the front cabinet of the
exhaust hood cannot be closed.
Electricity Connection
MODENA Exhaust Hood is designed for 220 volt electricity input, single phase with 50 Hz of frequency. This
appliance uses a double-insulated power cord (2 parallel cords) and should not be connected to a grounding wire.
SX 9512 L and SX 7511 L
Exhaust hood is equipment which sucks smoke and cooking fragrance. With a vent hood, your kitchen will be
free from oil particles that may produce bad odor
1. Check the strength of wall on which the exhaust hood is to be
installed. Make sure the wall can sustain the weight / load of the vent
hood.
2.
The exhaust hood should be installed precisely over the stove at a
vertical distance of 65 - 75 cm from the stove surface.
INSTALLING THE EXHAUST HOOD ON WALL
Exhaust hood must be installed perpendicularly to prevent the oil from flowing to one side and dripping out
of the vent hood.
PREPARATIONS TO BE MADE BEFORE INSTALLING THE EXHAUST HOOD
Remove the exhaust hood from its packaging and put it on an even place (i.e. Tables).
Open the grid by sliding the right and left grid locker (6) and then pull it. Remove the spigot / flange (pipe connector)
and the hole cover from the plastic bag.
INSTALATION OF EXHAUST HOOD
Exhaust hood can be installed on the concrete (brick) wall or the bottom part of the kitchen set.
Installing on concrete (brick) wall
1.
To install the hood in the wall, drill 4 holes on the wall and the diameter each holes is 8 mm, or according
to fisher size at the possible place based on the distance of the center of the back hole of the hood.
Caution:
Before drilling, make sure that there's no cable installation, water
pipe and installation inside the wall.
2. Insert fisher/nut into the holes.
3. Pair the screw in the 2 above holes and leaving the 1 cm distance from the wall.